From mrbarton@ix.netcom.com Mon Dec 18 01:12 MST 1995
>Received: from ix7.ix.netcom.com (ix7.ix.netcom.com [199.182.120.7]) by uucp-1.csn.net (8.6.12/8.6.12) with ESMTP id WAA26480 for <tesla@grendel.objinc.com>; Sun, 17 Dec 1995 22:44:32 -0700
Date: Sun, 17 Dec 1995 22:17:59 -0800
From: mrbarton@ix.netcom.com (Mark Barton)
Subject: Re: Scoping of Secondaries
To: tesla@grendel.objinc.com

Steven and others,

You can lower the output impedance of a signal generator considerably 
by winding an output transformer.  I used a 1" pot-core and wound a 
600ohm to 10ohm transformer that I use on the output of an HP200-CD sig 
gen.  The lowering of output voltage on this type of generator is not a 
problem since they put out plenty.

Zap,
Mark

=======================================================================

>
>This raises some other questions.  I'm assuming that a signal 
>generator with an even lower impedence would give an even more 
>accurate value for Q, but since I have what I have, is there any way 
to 
>compensate for this resistance?  Also, rather than just believing the 
>label that says 75 ohms by the output jack, what can I do to confirm 
or 
>compute the actual impedence of my signal generator?  Would I be 
>able to measure the open circuit voltage and the short circuit current 
(at 
>say, 60Hz) and use these values to calculate the internal resistance, 
or 
>is there something more complicated involved?
>



