OS/2 2.1 Drivers for OAK-087 ProStar SuperVGA Adapters
======================================================

These files must be copied to a diskette labelled as follows:

            OS2 DRVS

This install requires that the 32-bit VGA (or our 32-bit SVGA)
driver is currently installed.  To install the drivers:

1.  Place OS/2 Drivers diskette into drive A (or other floppy drive).

2.  Open an OS/2 session (full-screen or window).

3.  Enter the following command:

        A:INSTALL  A:  C:

        where:  A: is the floppy drive
                C: is the OS/2 boot drive

4.  INSTALL.CMD will copy files to the OS/2 drive, present
a message indicating that it is about to start the OS/2 Display
Driver Install utility (DSPINSTL), and prompt the user to press
any key.

5.  When the Display Driver Install main panel appears, the
Primary Display should indicate Video Graphics Array.  If so,
select OK and proceed to step 6.  If Video Graphics Array is not
indicated, select Primary Display and click on OK.

6.  Highlight the Driver/Resolution desired and click on OK.

7.  When the Source Directory panel appears, choose the floppy
drive that contains the OS/2 Driver diskette and click on Install.

8.  When the main panel appears again, click on Cancel.

9.  A message box will appear, indicating that the user must perform
a shutdown so that the changes will take effect.  Click on OK.

10.  Perform a shutdown and restart the system.

