.PP
The purpose of \fBghostreader\fP is to update Program Specification 
File ( PS or *.prog file) 
so that it is consistent with the C source code and man pages
of an application program that was originally generated with \fBghostwriter\fP.
The SOURCE of information for \fBghostreader\fP is from marked segments of the 
*.c, *.h, l*.c, *.1, and *.3 files. The DESTINATION of extracted information
is the *.prog file, where '*' is the name of the program in question.
.PP
Before clicking on "GHOSTREADER", you must fill out the name of the
program, "Program Name",
that you wish to read from.  It must be the same as the "*"
on your *.pane and *.prog files.
Do not use a configuration file (*.conf) until you are very familiar
with the \fBghost\fP routines.  Since you are not using a config file,
the install logical should be set to "Install in Local Directory".
.PP
In most cases, the program has more than just driver code, though it
is possible for your driver to rely on other existing libraries.
So typically, you will have the logicals set to "Library Code" and
"Man3 Page" so that these files are used to update your *.prog.
.PP
The success of the "GHOSTREADER" is reported in a pop-up help window.
