.LP
The Rectangle may be placed using either the MOUSE or the KEYBOARD.
.LP
Placing the Rectangle with the Mouse
.IP
To place with the MOUSE, set the "Placement mode:" logical to "by MOUSE".  
Click on the "CREATE RECTANGLE" action button and move the mouse into the 
graphics workspace.  One corner of the specified Rectangle will be placed 
wherever the mouse is first clicked.  Holding the button down, one may rubber-
band the Rectangle, placing the opposite corner where desired.  
.LP
Placing the Rectangle with the Keyboard
.IP
To place a rectangle using the KEYBOARD, set the "Placement mode:" logical 
to "Place by KEYBOARD".  Fill in the "Corner x", "Corner y" parameter boxes 
with the desired DEVICE COORDINATES  of one Rectangle corner. 
Fill in the "Diag x" and "Diag y" parameters with the device coordinates 
of the opposite corner of the Rectangle.  Note that care must be taken to 
specify device coordinates that not only are within the graphics workspace, 
but also that allow enough room for the entire Rectangle to appear within the 
graphics workspace.   
.LP
Moving, Deleting, Copying, Raising and Lowering
.IP
Once the Rectangle has been created & placed, it may be moved by dragging it 
across the workspace with the mouse.  By clicking the mouse on the Rectangle, 
and then clicking on the "DELETE" subform action button, the Rectangle can be 
deleted.  Similarly, the Rectangle may now be copied, raised or lowered by
clicking the mouse on the Rectangle to select it, and then clicking on the 
desired action button.
