.LP
Placing the Line with the Mouse
.IP
The Line may be placed using either the MOUSE or the KEYBOARD.  
To place with the mouse, set the 
"Placement mode:" logical to "by MOUSE".  Click on the "CREATE LINE" action
button and move the mouse into the graphics workspace.  One endpoint of the 
Line will be placed at the first mouse click.  The Line will rubber-band 
after the mouse until the second mouse click places the second endpoint 
of the Line.
.LP
Placing the Line with the Keyboard
.IP
To place a line using the 
keyboard, set the "Placement mode:" logical to "by KEYBOARD".  Fill in the
"Start x", "Start y" parameter boxes with the desired \fIdevice 
coordinates\fP  of one Line endpoint.  Fill in the "End x" and "End y" 
parameters with the \fIdevice coordinates\fP of the other endpoint of the
Line.  Note that care must be taken to specify device coordinates that not 
only are within the graphics workspace, but also that allow enough room for 
the entire Line to appear within the graphics workspace.   
.LP
Moving, Deleting, Copying, Raising and Lowering
.IP
Once the Line has been created & placed, it may be moved by dragging it 
across the workspace with the mouse.  By clicking the mouse on the Line, 
and then clicking on the "DELETE" subform action button, the Line can be 
deleted.  Similarly, the Line may now be copied, raised or lowered.
