.LP
Placing the Circle with the Mouse
.IP
The Circle may be placed using either the MOUSE or the KEYBOARD.  
To place with the mouse, set the "Placement mode:" logical to "by MOUSE".  
Click on the "CREATE CIRCLE" action button and move the mouse into the 
graphics workspace.  The center of the Circle will be placed at the first 
mouse click.  The Circle will grow or shrink with movement of the mouse 
until the second mouse click places the edge of the circle.  
.LP
Placing the Circle with the Keyboard
.IP
To place a Circle using the keyboard, set the "Placement mode:" logical to 
"by KEYBOARD".  Fill in the "Center x", "Center y" parameter boxes 
with the desired DEVICE COORDINATES of the Circle center.  Next fill in 
the "Edge x" and "Edge y" parameters with the device coordinates of a 
point on the perimeter of the Circle.  Note that care must be taken to 
specify device coordinates that not only are within the graphics workspace, 
but also that allow enough room for the entire Circle to appear within 
the graphics workspace.   
.LP
Moving, Deleting, Copying, Raising and Lowering
.IP
Once the Circle has been created & placed, it may be moved by dragging it 
across the workspace with the mouse.  By clicking the mouse on the Circle, 
and then clicking on the "DELETE" subform action button, the Circle can be 
deleted.  Similarly, the Circle may now be copied, raised or lowered, by first
clicking the mouse on the Circle to select it, and then clicking on the 
desired action button.
