NAME

irdaattach, irda — attach serial lines to IrDA frame driver

SYNOPSIS

DESCRIPTION

irdaattach is used to assign a tty line to an IrDA frame level driver. The following operands are supported by irdaattach:

-d dongle

Sets the dongle type. The following dongles are supported:

none

No dongle

tekram

Tekram IR-210B

jeteye

Extended Systems JetEye

actisys

ACTiSYS IR-220L

actisys+

ACTiSYS IR-220L+

litelink

Parallax LiteLink

girbil

Greenwich GIrBIL

The default is none.

-f

Print the name of the IrDA frame device that should be used to access the frames.

-H

Turn on DTR/CTS flow control. By default, no flow control is done.

-h

Turn on RTS/CTS flow control. By default, no flow control is done.

-l

Turn on the CLOCAL flag, making it possible to run SLIP on a cable without modem control signals (e.g., DTR, DSR, DCD).

-m

Maintain modem control signals after closing the line. Specifically, this disables HUPCL.

-n

Do not detach from invoking tty.

-p

Print process id to file.

ttyname

Specifies the name of the tty device. Ttyname should be a string of the form ‘ttyXX’, or ‘/dev/ttyXX’.

Only the super-user may attach a network interface.

The frame driver is detached by killing the irdaattach process.

EXAMPLES

irdaattach tty00
ircomm -Y -d `irdaattach -p -f /dev/tty02`

DIAGNOSTICS

Messages indicating that the specified interface does not exist, the requested address is unknown, or that the user is not privileged but tried to alter an interface's configuration.

SEE ALSO

daemon(3), irframe(4), irframetty(4), slattach(8)

HISTORY

The irdaattach command appeared in NetBSD 1.6.